Differences

This shows you the differences between two versions of the page.

--- engine_details:intake_manifolds [2020/03/30 18:09] – created ben
+++ engine_details:intake_manifolds [2020/04/14 17:30] (current) – ben
@@ Line 1: / Line 1: @@
 ====== Intake Manifolds ======
+===== Naturally-Aspirated Intake Manifolds =====
+==== L36 and L26 Front-Wheel Drive ====
+L36 and L26 engines both received the same lower intake manifold, however the upper intake manifold/plenum is slightly different between them.
+Below is an image of the lower intake for both of these:
+{{:engine_details:2a4291dd38f589c6ea94b372721658f2.png}}
+L36 engines were equipped with plastic upper intake manifolds that were black in color.
+{{:engine_details:dd42ea7062901c439c17cc6933225cbb.png}}
+The L26 engines were equipped with an aluminum intake manifold that was silver.
+{{:engine_details:27a1f0e5f96fe8843e5b97c27af78aa9.png}}
+These intake manifolds had a separate piece inside the manifold that extended the intake runners into the roof of the plenum to help increase the amount of low-end torque the engines would produce.
+{{http://momentoffame.com/photopost/data/523/UIM_009.jpg?nolink&|uim_009.jpg}}
+These can be replaced with an aftermarket insert which tends to trade low-end torque for top-end horsepower by shortening the intake runners.
+==== L36 F-body ====
+L36's in f-body's were equipped with an intake where the throttle body was located on the front of the motor to help these engines fit better into the f-body.
+{{http://i.imgur.com/OALVnbc.jpg?nolink&|oalvnbc.jpg}}
+In 1999 f-body's received a slightly revised intake manifold for the drive by wire throttle body. In these intake manifolds, the thottle body opening is not turned down anymore like the earlier manifolds.
+This can be seen in this image of a 99+ f-body L36:
+{{https://www.speednik.com/files/2015/06/l36.jpg?nolink&|Fourth-Generation Camaro Engines}}
+The f-body intake has shorter runners than the front-wheel drive vehicles so it would seem to favor top-end power slightly better than the front-wheel drive manifolds would from the factory.
+==== L36 Holden ====
+L36's Holden cars were equipped with an intake manifold that was faced sideways.
+{{https://i.ebayimg.com/images/g/yy0AAOSw9uFW93GJ/s-l300.jpg?nolink&|VS ECOTEC HOLDEN COMMODORE V6 INTAKE MANIFOLD. | eBay}}
+{{:engine_details:f90a608d56cccba1ce242c4577660760.png}}
+===== Supercharged Intake Manifolds =====
+L32 and L67 vehicles both came equipped with the same intake manifold from the factory with no apparent changes.
+{{:engine_details:15897cc6d78f9e2d6590d24abeac9dd0.png}}
+=====   =====