Differences

This shows you the differences between two versions of the page.

--- tuning_resources:factory_pcm:e85 [2020/03/30 05:47] – ben
+++ tuning_resources:factory_pcm:e85 [2023/02/04 00:20] (current) – [Injector Skew Percent Table] ben
@@ Line 5: / Line 5: @@
 ===== Scaling the Injectors =====
-There are two ways of scaling the amount of fuel needed "properly" without skewing other tables.
+There are two ways of scaling the amount of fuel needed "properly" without skewing other tables.\\
+ <font 16px/inherit;;inherit;;inherit>Only do one of these two options!</font>
 ==== Injector Flow Rate Table ====
-Adjust your base injector flow rate table to tell the PCM your injectors are smaller than they actually are.
+One option for adjusting for E85 fueling is to adjust your base injector flow rate table to tell the PCM your injectors are smaller than they actually are.
 If you're using Tiny Tuner, just go ahead and add 33% to the whole table across the board
 {{:tuning_resources:factory_pcm:782c9415373cd7438b1f2e5c9f3a6566.png}}
 ==== Injector Skew Percent Table ====
-There is a table you can find in Tiny Tuner called "Injector Skew Percent". Typically this would be used to adjust for injectors that aren't flow matched perfectly. You can use this table to adjust for your E85 tune.
+The other option is to use a table you can find in Tiny Tuner called "Injector Skew Percent". Typically this would be used to adjust for injectors that aren't flow matched perfectly. You can use this table to adjust for your E85 tune.
 Just add 33% to each cell in the table.
 {{:tuning_resources:factory_pcm:cc0b83fad59902b608c3b865f962dfb5.png}}
 ===== Cold Starts =====